Login: Password: New User
  Springs > Extension Springs > English Hooks


Reference

 Extension springs with english hooks

Searching among springs, orders online


       



Description of parameters for extension springs with english hooks




  Physical parameters
  • d (wire diameter): This parameter describes the diameter of wire used as material for spring.
  • De (external diameter): External diameter of a spring concerns both hooks and coils. Tolerance for this parameter is (+-)2%(indicative).
  • H (Hole): This is minimum diameter of hole in which spring can work. Tolerance for this parameter is (+-)2%(indicative).
  • Ln (Maximum length): Maximum acceptable extension length for a spring. It is also the maximum extension for static applications. Tolerance for this parameter is (+-)15%(indicative).
  • Fn (Maximal force): Maximal acceptable force which can operate on a spring. It is also the maximum force for static applications. Tolerance for this parameter is (+-)15%(indicative).
  • L0 (free length): Free length is measured in spring's free state. Tolerance for this parameter is (+-)2%(indicative).
  • Nr of coils: This is a total number of coils in a spring - in the picture above it is equal to six.
  • R (Spring rate): This parameter determines spring's resistance, while it is working. It is measured in 1 DaN/mm = 10 N/mm. Tolerance for this parameter is (+-)15%(indicative).
  • L1 & F1 (length under charge F): The charge F1 at length L1 can be calculated using the equation : F1 = Fn - R(Ln-L1). Equation derived from the previous for calculating L1 = Ln - (Fn-F1)/R.
  • Hooks: Extension springs with English hooks have both hooks closed forming a ring. Both hooks lie in the same plane.
  • Reference Number: All springs are identified by a unique reference: type . (De * 10) . (d * 100) . (L0 * 10) . material ; for english extension springs, type is a letter "T", materials are identified by the following letters: "A" or "I". Example: T.063.090.0100.A is the extension spring with the external diameter 6.3 mm and the free length 10mm, produced from 0.9 mm music wire .
  Materials
  • A (Music Wire): Steel that conforms to the EN 10270-1 class SH standard.
  • I (Inox steel): Inox 18/8 mark Z10 CN 18.09.
  Tolerances
  • maximal force: Tolerance for the maximal force is (+-)15%(indicative).
  • maximal length: Tolerance for the maximal length is (+-)15%(indicative).
  • Spring rate: Tolerance for the spring rate is (+-)15%(indicative).
100 000 articles !
Orders online

0.00 EUR   
Technical information

  Best prices
   Phone: +44 20 8123 0339    Site Map